The Morso Model F cuts double mitre at 45 degrees and single mitre up to 90 degrees. Tenon, mortise joints, and a wide variety of angled cuts can also be made with this machine. It leaves the cut surface of the wood perfectly smooth and accurate, requiring no further preparation before joining.
The horizontal movement of the knife block is adjustable in steps. The sliding longitudinal stop and measuring scale ensure accurate repeat work. The F has a special lever system for wide profiles - the knife block has stepped horizontal adjustment allowing progressive cuts until the full width is achieved. Twin return springs automatically bring the knives back to start position.
The mitres can be done a lot closer with the guillotine, than the mitre saw! Our Mitre Guillotine is supplied with perspex safety guard, waste chute, sliding longitudinal stop, measuring scale, adjustable fences (45-90 degrees), and adjustable rebate supports.
Materials that you can use on this machine: Solid timber only.
All training/assessments are to ensure that you are using the machines safely and correctly, overall.
You will be taught how to turn the machines on/off, location of emergency stop, and all safety measures & ground rules for each machine.
If you already know how to use the machine, be sure to book an assessment before use. The assessments are put in place for everyone's benefit, so our technicians can oversee that you will use the machines correctly, but most importantly, safely!
|Cutting Width Max. 100mm|
|Cutting Height Max. 160mm|
|Square Cutting Max. 65/65mm|
|Single Mitre up to 90°|
|Double Mitre 45°|
|Measuring Scale up to 1500mm|
|GET STARTED TRAINING||N/A|