Skip to main content

Morgan Rushworth PSR 50/155


Morgan Rushworth PSR 50/155



This model comes with a full set of rolls for the bending flat bar, flat bar on edge, round bar, square bar and box section.

The bottom rolls are both powered which provides positive traction, whilst the top ‘idler’ roll is adjustable to determine the bending radius of the workpiece according to its height setting.

Materials that can be used on this machine: Any metals.

The Section Rollers are accessible to all members who have passed an assessment for them and are one of the shared access metalwork machines.


All training/assessments are to ensure that you are using the machines safely and correctly, overall.

You will be taught how to turn the machines on/off, location of emergency stop, and all safety measures & ground rules for each machine.

Things you will learn in this training:

- Setting up the machine

- Troubleshooting

If you already know how to use the machine, be sure to book an assessment before use. The assessments are put in place for everyone's benefit, so our technicians can oversee that you will use the machines correctly, but most importantly, safely!


Technical Spec 
Flat Bar on Edge at 800mm Ø mm 60 x 10
Flat Bar as Flat at 750mm Ø mm 120 x 15
Square Bar at 800mm Ø mm 35
Rectangular Hollow Section at 850mm Ø *mm 50 x 40 x 3
Square Hollow Section at 830mm Ø mm 60 x 60 x 3 (With optional special rolls)
Angle Iron Toe Out at 850mm Ø mm 50 x 50 x 5
Angle Iron Toe In at 1200mm Ø mm 50 x 50 x 5
Tee Section Toe Out at 650mm Ø mm 50 x 50 x 5
Tee Section Toe In at 900mm Ø mm 50 x 50 x 5
Tee Section Toe Up/Down at 900mm Ø mm 50 x 50 x 5
Channel Legs Out at 1200mm Ø * mm 60 x 30 x 6
Channel Legs In at 1200mm Ø * mm 60 x 30 x 6
Power kW 1.5
Rolls Diameter mm 155
Shaft Diameter mm 50
Bending Speed m/min4.3



Cookie Policy

This website uses a number of essential cookies to operate. Please read our privacy policy for more information